Aqprox! appIP01WV4 Manual de usuario descargar pdf (Pagina 107)

APPROX IBERIA S.L. More Security, More Convenience http://www.approx.es

107

Low: Choose it, the IO Pins work as a switch which is switching off.

Figure 10.2

3.18.4 IO Pins for IO Alarm Linkage

Figure 10.3

I/O PINS: 1 Output 2 Output 3 Alarm input 4 Input (GND)

Input pins: The input pins can be used for 1-way external sensor input. For example, you may connect a

Person Infrared Sensor (PIP) to it for motion detection. When external sensor triggered, IP CAMERA can be

programmed to send an email with picture or control the internal relay output.

If you link an external alarm device with Pin3 and Pin4, when select Alarm Input Armed (Figure 10.0),

external alarm is enabled.

Output pins: The output pins can be enable IO linkage on alarm.

You can also use

& to control IO output Switch ON/OFF (See Figure 4.4).

NOTE: All the pins work as switch only.

3.19 Send Mail on Alarm

Choose it, it will sent picture and mail inform to customer’s e-mail once alarmed. (Firstly you should finish the

Mail Service Settings. Figure 9.1)

NOTE: It usually will send 6 snapshots by one email to your mailbox for each alarm triggered. Each alarm will

last for 60 seconds.

Upload Image on Alarm

Enable Upload Image on Alarm to set upload images to FTP once alarmed.

Upload Interval: Set the upload interval (Seconds).

NOTE: The total alarm time is 60 seconds.

Figure 10.4

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 173 174

Sin comentarios

Aqprox! appIP01WV4 Manual de usuario Pagina 107