
APPROX IBERIA S.L. More Security, More Convenience http://www.approx.es
114
4.1.16 Why pop-up the prompt” Fail to connect to the device…”?
This prompt only appeared in the case of using multiple cameras.
When you set multiple cameras, the device status light change to yellow
, then please make sure the
camera connected and works correctly.
4.2 Default Parameters
Default network Parameters
IP address: dynamic obtain
Subnet mask: dynamic obtain
Gateway: dynamic obtain
DHCP: Disabled
DDNS: factory DDNS and third party DDNS
Username and password
Default administrator username: admin
Default administrator password: No password
5. Specifications
Image Sensor
Sensor 1/4” Color CMOS Sensor
Resolution 640 x 480 Pixels (300k Pixels)
IR Lens f: 6mm, F 2.0 (3.6mm lens optional)
Viewing Angle 60 Degree (3.6mm lens is 90Degree)
Minimum Illumination 0.5Lux @ F2.0
Video/Image Setting
Video Compression MJPEG
Video Frame Rate 15fps(VGA), 30fps(QVGA)
Resolution 640 x 480(VGA), 320 x 240(QVGA)
Flip Mirror Images Vertical / Horizontal
Light Frequency 50Hz, 60Hz or Outdoor
Video Parameters Brightness, Contrast
Audio talk-back Built-in Mic
Communication
System Interface 10Base-T/100Base-TX Ethernet Port
Supported Protocol TCP/IP,DHCP,SMTP,HTTP,DDNS,UPNP,PPPoE, FTP, DNS, UDP, GPRS
Wireless LAN Support wireless network (Wi-Fi/802.11/b/g)
WEP Encryption Disable / 64 bit / 128 bit
WPA/WPA2 Encryption TKIP / AES
Physical / Environment
Power Supply 5VDC/2A External Power Adapter
Power Consumption 5W (Max.)
Comentarios a estos manuales